Liman-Tech at the NPPA forum in Kazan: what we bring and what we offer
We took part in the open industrial automation forum on 20–21 October. A page for forum guests covers the Larus, Passer and Strix architecture, our proposal on describing raw signal exchange, and analysis of a customer's own data.
The NPPA forum on open industrial automation took place in Kazan on 20–21 October. For more than five years we have been developing and deploying a system based on the IEC 61499 standard: our own controllers, software and algorithms built on open standards. We invite you to develop and deploy together for your task, from electronics and firmware to logic and software.
We have prepared a separate page for forum guests (in Russian). It covers:
- Architecture from sensor to platform. Passer devices collect vibration, current and voltage; Larus on Astra Linux computes on site and runs IEC 61499 logic; Strix brings together equipment state, forecasts and operator advice. Data moves over OPC UA or MQTT.
- A proposal to the community. AI models need raw signals, not only values: for diagnostics, control-system calibration and training. We are ready to discuss in a working group the exchange format: sensor metadata, common time base, block and file format, triggered recording, and exchange with an industrial data platform.
- Analysis of your data. An export from your system is enough: we review operating modes, estimate the optimisation potential and suggest how to confirm it with measurements. The result is a report and a pilot plan. We do this work together with our academic partners.
- Contact and business card. The contact of Aleksandr Vasilev, Managing Director, comes with a QR business card: it can be saved to a phone straight from the page.
Forum results are in a separate post; the talk slides (in Russian) are on the forum page.
Page for forum guests · Analysis of your data · Send a request